| Digital Input Specifications | |||
| Model No. | PFXSTC6300TADDKE | PFXSTC6300TADDCE | |
|---|---|---|---|
| Input terminal | IN0...IN15 | ||
| Rated voltage | 24 Vdc | ||
| Maximum allowable voltage | 28.8 Vdc | ||
| Input type | Sink/Source Input | ||
| Rated current | 2.25 mA | ||
| Input resistance | 10.7 kΩ | ||
| Input points | 16 | ||
| Input points | 1 | ||
| Common design | 16-point/1 common line | ||
| Operation range | ON voltage | 15...28.8 Vdc | |
| OFF voltage | 0...5 Vdc | ||
| ON current | 2.25 mA | ||
| OFF current | 1.0 mA or less | ||
| Filtering | Normal input | 0.5 ms x N (N is 0 to 40) | |
| High-speed counter (IN0, IN2, IN4, IN6) |
None, 4 μs, or 40 μs | ||
| Input signal display | No LED indicators | ||
| Status display | None | ||
| Isolation | Yes | ||
| External connection | 38 pin connector (used with Output section) | ||
| Cable length | Normal input | Maximum 50 m (164 ft) | |
| High-speed counter / Pulse catch input (IN0, IN2, IN4, IN6) |
Maximum 10 m (33 ft) | ||
Input Circuit
(A) 24 Vdc External power supply
(B) Source type
(C) Sink type
| Digital Output Specifications | |||
| Model No. | PFXSTC6300TADDKE | PFXSTC6300TADDCE | |
|---|---|---|---|
| Input terminal | OUT0...OUT3 | OUT4...OUT15 | |
| Rated voltage | 24 Vdc | ||
| Rated voltage range | 20.4 Vdc...28.8 Vdc | ||
| Output type | PFXSTC6300TADDKE: Sink output | ||
| PFXSTC6300TADDCE: Source output | |||
| Maximum load current | 0.3 A/point, total 3.2 A | ||
| Minimum load current | 1 mA | 1 mA | |
| (Pulse/PWM output unavailable) | |||
| Output voltage drop | 1.5 Vdc or less | ||
| Output delay time | OFF to ON (With output at 24 Vdc, 200 mA) | 5 μs or less | 50 μs or less |
| ON to OFF (With output at 24 Vdc, 200 mA) | 5 μs or less | 50 μs or less | |
| Type of output | Transistor output | ||
| Common lines | 2 | ||
| Common design | 8-point/1 common line x 2 | ||
| External connection | 38 pin connector (used with Input section) | ||
| Output protection type | Output is unprotected | ||
| Output points | 16 | ||
| Output signal display | No LED indicators | ||
| Status display | None | ||
| Isolation | Yes | ||
| External power supply | For Signal: 24 Vdc | ||
| Cable length | Normal input | Maximum 150 m (492 ft) | |
| Pulse/PWM output | Maximum 5 m (16 ft) | ||
*5 (Example) If the output current is 24 Vdc 50 mA, the output delay time (OFF to ON) is 1.5 μs. If more responsiveness is required or the load is light, install an external dummy resistor to increase the amount of current.
NOTE: The output terminals are not electrically protected. A short circuit or poor connection of the output wiring may cause burnout of external devices and this product. If there is a risk of the current exceeding the output rating, connect an appropriate fuse to each output terminal.
| High-Speed Counter | ||
| Model No. | PFXSTC6300TADDKE | PFXSTC6300TADDCE |
|---|---|---|
| Input | 24 Vdc open collector | 24 Vdc open collector |
| Input points | CT0 (IN0), CT1 (IN2), CT2 (IN4), CT3 (IN6) | CT0 (IN0), CT1 (IN2) (used as pair) CT0: A Phase, CT1: B Phase CT2 (IN4), CT3 (IN6) (used as pair) CT2: A Phase, CT3: B Phase |
| Minimum pulse width (Pulse Input) |
 |
|
| Count speed (Rise, Fall time) |
 t = 1 μs or less (100 kpps) |
|
| Phase | 1 phase | 90 degree phase differential |
| 2 phase signal | ||
| 1 phase+ directional signal | ||
| High speed count frequency | 100 kpps | 50 kpps |
| Count edge designation | Available | Not available |
| Count register | 32 bit UP/DOWN counter | |
| Counter mode change | Set through software | |
| Upper/Lower limit setting | Not available | |
| Preload - Prestrobe | Available | |
| Marker Input (Counter value clear) | None | IN3, IN7 |
| Pulse Catch Input | ||
| Model No. | PFXSTC6300TADDKE | PFXSTC6300TADDCE |
|---|---|---|
| Input | 24 Vdc open collector | |
| Input points | IN0, IN2, IN4, IN6 | |
| Minimum pulse width (Pulse Input) |
Input signal ON width t = 5 μs or more |
|
| Pulse Output | ||
| Model No. | PFXSTC6300TADDKE | PFXSTC6300TADDCE |
|---|---|---|
| Output points | 4 | |
| Output method | PLS0...PLS3 (OUT0...OUT3)*6 | |
| Load voltage | 24 Vdc | |
| Maximum load current | 50 mA/1-point | |
| Minimum load current | 1 mA | |
| Maximum output frequency | Up to 65 kHz/1-point*6 | |
| Pulse acceleration / Deceleration speed | Available | |
| ON duty | 50% ±10% (at 65 kHz)*7 | |