Specifications of PFXSP5500TPD (Display) / PFXSP5B10 (Box Module)

Manual | Technical Resources | PFXSP5500TPD DatasheetPFXSP5B10 Datasheet  | Software | Certifications | SP5000 Flyer

Display Specifications

Display Type TFT Color LCD
Display Size 10.4”
Resolution 800 x 600 pixels (SVGA)
Auto Scaling Yes
Effective Display Area W211.2 x H158.4 mm(W8.31 x H6.24 in.)
Display Colors 16 million colors
For details about Display Colors, refer to the manual for your screen editing software.
Backlight White LED
(Not user replaceable. When replacement is required, contact your local distributor.)
Backlight Service Life 50,000 hours or more (continuos operation at 25 °C [77 °F]
before backlight brightness decreases to 50%
Brightness Control 0...100 (Adjusted with touch panel or software)
Brightness Sensor Yes
Type Resistive Film (analog, multi-touch)
Resolution 1,024 x 1,024
Service Life 1 million times or more

Electrical Specifications

Rated Input Voltage 12...24 Vdc
Input Voltage Limits 10.8...28.8 Vdc
Voltage Drop 12 Vdc: 1.25 ms or less
24 Vdc: 5 ms or less
Power Consumption
(Primary Power Supply
[including power loss])
Max. 65 W
In-Rush Current 30 A or less
Voltage Endurance 1,000 Vac, 20 mA for 1 minute (between charging and FG terminals)
Insulation Resistance 500 Vdc, 10 MΩ or more (between charging and FG terminals)

Environmental Specifications

Safety Standard
Air Temperature
0...60 °C (32...140 °F)
Storage Temperature -20...60 °C (-4...140 °F)
Surrounding Air and
Storage Humidity
10%...90% RH (Non condensing, wet bulb temperature
39 °C [102.2 °F] or less)
Dust 0.1 mg/m3 (10-7 oz/ft3) or less (non-conductive levels)
Pollution Degree For use in Pollution Degree 2 environment
Corrosive Gases Free of corrosive gases
Atmospheric Pressure
(Operating Altitude)
800...1,114 hPa (2,000 m [6,561 ft] or lower)
IEC/EN 61131-2 compliant
5...9 Hz Single amplitude 3.5 mm (0.14 in.)
9...150 Hz Fixed acceleration: 9.8 m/s2
X, Y, Z directions for 10 cycles (approx. 100 min.)
Shock Resistance IEC/EN 61131-2 compliant
147 m/s2, X, Y, Z directions for 3 times
Noise Immunity Noise Voltage: 1,000 Vp-p
Pulse Duration: 1 μs
Rise Time: 1 ns
(via noise simulator)
Discharge Immunity
Contact Discharge Method: 6 kV (IEC/EN 61000-4-2 Level 3)
NOTE: When using any of the options for this product, make sure to check the specifications for any special conditions or cautions that may apply to this product.


Application Memory Screen Size:  64MB *SD card
Free Space:  None
Backup Memory NVRAM 320 KB
Control Memory 64KB

Interface Specifications(Display)

USB (Type A)
Connector USB 2.0 (Type A) x 1
Power Supply Voltage 5 Vdc ±5%
Maximum Current
500 mA
Maximum Transmission
5 m (16.4 ft)
USB (mini-B)
Connector USB 2.0 (mini-B) x 1
Maximum Transmission
5 m (16.4 ft)
  1. When using the Display Module with the Power Box, you can connect only one of each type of USB device, such as one USB flash drive, one transfer cable, or one bar code reader. If you connect multiple devices that are the same type, only the first device will work.

Interface Specifications(Box Module)

Serial Interface COM1 Asynchronous Transmission RS-232C/422/485
Data Length 7 or 8 bits
Stop Bit 1 or 2 bits
Parity None, odd, or even
Data Transmission Speed 2,400(1,200)...115,200 bps
Connector D-Sub 9 pin (plug)
Serial Interface COM2 Asynchronous Transmission RS-232C/422/485
Data Length 7 or 8 bits
Stop Bit 1 or 2 bits
Parity None, odd, or even
Data Transmission Speed 2,400(1,200)...115,200 bps,
187,500 bps(MPI)
Connector D-Sub 9 pin (plug)
USB (Type A) Interface Connector USB 2.0 (Type A) x 2
Power Supply Voltage 5 Vdc ±5%
Maximum Current Supplied 500 mA/port
Maximum Transmission Distance 5 m (16.4 ft)
USB (mini-B) Interface Connector USB 2.0 (mini-B) x 1
Maximum Transmission Distance 5 m (16.4 ft)
Ethernet Interface Standard IEEE802.3i/IEEE802.3u/IEEE802.3ab,
Connector Modular jack (RJ-45) x 2
SD Card Interface SD Card SD Card Slot(System) x 1
SD Card Slot(Storage) x 1
CFast Card Interface CFast Card -
Expansion Unit Interface Expansion Unit Fieldbus Unit x 1
Video Interface DVI-D -
Connector -
Sound Input Interface Sound Input -
Connector -
Sound Output Interface Speaker Output 300 mW (Rated Load: 8 Ω,
Frequency: 1 kHz)
LINE Output Rated load: 10 kΩ or more
Connector 2-piece terminal block (AUX) x 1
AUX Output Interface AUX Output Alarm Output/Buzzer Output
Rated Voltage 24 Vdc
Rated Current 50 mA or less
Connector 2-piece terminal block (AUX) x 1

Structural Specifications

Grounding Functional grounding: Grounding resistance of 100 Ω, 2 mm2 (AWG 14) or thicker wire,
or your country’s applicable standard (same for FG and SG terminals).
Cooling Method Natural air circulation
Structure *2 When using a factory-installed front USB cover: IP65F, IP67F.
When using a front USB cover as an option: IP66F, IP67F, Type 4X (Indoor Use Only)/13
* The front face of this product when properly installed in an enclosure and
not using the front panel USB port.
NOTE: The option is a front USB cover with screw manufactured by Pro-face
 (Model Number PFXZCDCVUS1).
W272.5 x H214.5 x D67 mm(W10.73 x H8.44 x D2.64 in.)
Dimensions(Box Module)
W188 x H131 x D45 mm(W7.4 x H5.16 x D1.77 in.)
Panel Cut
W259 x H201 mm(W10.2 x H7.91 in.)*3
Panel thickness area: 1.6...5 mm (0.06...0.2 in.)*4
Weight *5 3.6 kg (7.88 lb) or less
  1. The front face of this product, installed in a solid panel, has been tested using conditions equivalent to the standards shown in the specification.
  2. For dimensional tolerance, everything +1/-0 mm (+0.04/-0 in.) and R in angle are below R3 (R0.12 in.)
  3. Even if the installation wall thickness is within the recommended range for the “Panel Cut Dimensions”, depending on wall’s material, size, and installation location of this product and other devices, the installation wall could warp. To prevent warping, the installation surface may need to be strengthened.
  4. The weight for the combined unit of Box Module and Display Module equals the sum of the weight for the Modules. 

External Dimensions

SP-5500TP with_Box_Module

Panel Cut-out

Model Name A B C
SP-5500TP 259 (+1/-0)
[10.2 (+0.04/-0)]
201 (+1/-0)
[7.91 (+0.04/-0)]
1.6...5 mm
(0.06...0.2 in.)

External Dimensions with cables

(Image of Open Box)
*1 Rotation area of the fastener
*2 Pitch of center of installation fastener screws